AIR-INSITE - SIMULATION WIZARD

How does Simulation Wizard determine the low & high pressure settings of individual air compressors?
This depends on a couple of factors! Firstly, is the Simulation linked to an audit or not?  And secondly, if the Simulation 'IS' linked to an au...
Tue, 26 Sep, 2017 at 2:12 PM
Why can't I edit the low and high pressure set point of the air compressors on the RED line of Simulation Wizard?
If the Simulation is linked to an audit '&' the low & high pressure set points were configured during the Audit Wizard configuration step ...
Wed, 23 Dec, 2020 at 9:04 PM
Why can’t I edit the equipment on the RED line of a Simulation linked to an audit?
Simulation Wizard aims to preserve the integrity of audit data.  Consequently when a Simulation is linked to an audit, the user will not be able to edit the...
Wed, 13 Sep, 2017 at 2:10 PM
How can I add my company logo to the front 'cover page' of a Simulation Report PDF?
OK, lets suppose we wanted to add our company logo to the title page of a Simulation Report PDF.  Firstly, have your logo available to upload!  In this exam...
Wed, 23 Dec, 2020 at 9:08 PM
How can I do a Simulation for an system with a Metacentre System controller already installed
Simulation Wizard assumes that NO System control is present, so this is a common question... The way to carry out such a Simulation is as follows... ...
Wed, 13 Sep, 2017 at 2:13 PM
I want to create my own report using the Simulation Wizard chart and graph
If you want to create your own report (i.e. instead of using the Create PDF feature within Simulation Wizard) you can do this in one of two ways. You c...
Wed, 23 Dec, 2020 at 11:01 PM
Where are kW, monetary and CO² savings derived from in Simulation Wizard?
OK, before we answer its worth observing that AIR-INSITE: Takes user settings from the user account: Uses kW to express power for all users and regions...
Wed, 13 Sep, 2017 at 2:23 PM
What is a CO² factor and where do I set it?
CO² factor is a value typically published by national governments interested in tracking statistical data associated with environmental or 'greenhouse g...
Wed, 13 Sep, 2017 at 2:25 PM
Can I use Simulation Wizard without doing an audit?
In a word, YES! Simulation Wizard provisions for both 'hypothetical' and 'real audit' scenarios.  There are many benefits to this approa...
Wed, 13 Sep, 2017 at 2:26 PM
When Metacentre System control is applied how can I establish how equipment is utilised?
In the annual Simulation sub tab, hover over the 'New specific efficiency' line (BLUE line) and the tool tip will display the specific efficiency fo...
Wed, 23 Dec, 2020 at 11:22 PM